It take many turns of the key to start the truck

Tiny
CFPSIMPSON
  • MEMBER
  • 1988 CHEVROLET SILVERADO
It take many turns of the key to start the truck. I replaced the ignition switch but it still is doing the same thing. It will eventually start but after many turns of the key. This has been an off again on again issue for some time, what are the chances is the starter if this has been on going for awhile.
Saturday, July 21st, 2012 AT 3:05 PM

5 Replies

Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
Hope the diagram is helpful.
Was this
answer
helpful?
Yes
No
Saturday, July 21st, 2012 AT 11:46 PM
Tiny
CFPSIMPSON
  • MEMBER
  • 3 POSTS
This is great thanks, one more question, the rod like in this diagram is sticking straight up, the switch when installed the slider is at a right angle to the rod. To get the rod into the slider the rod would have to rotate 90 degrees and it doesn't want to do this. Is the rod suppose to rotate to go into the slider?

Thanks Ron
Was this
answer
helpful?
Yes
No
Sunday, July 22nd, 2012 AT 11:49 AM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
I have not done this before so am not able to provide you with any instructions but here are 2 different methods depending on the type of switch used.

Type 1.
To install, move switch slider to far left position and then 2 detents to the right on non key-release switches. On key-release switches, move switch slider to the far left position. On all types, position rod in hole and install switch to steering column.

Type 2.
Place lock and switch in "LOCK" position. Install actuating rod into switch and install switch using mounting screws. Tighten slowly. Ensure switch position is not changed.
Was this
answer
helpful?
Yes
No
Sunday, July 22nd, 2012 AT 2:05 PM
Tiny
CFPSIMPSON
  • MEMBER
  • 3 POSTS
Thanks I figured it out. It was staring me right in the face!

Ron
Was this
answer
helpful?
Yes
No
Sunday, July 22nd, 2012 AT 2:37 PM
Tiny
CADIEMAN
  • MECHANIC
  • 3,544 POSTS
Remove the switch plug in the new 1. Use a screw driver in the slot. It should slide foward and start the car. Pull it back it gos to accesory.
Was this
answer
helpful?
Yes
No
Sunday, July 22nd, 2012 AT 3:00 PM

Please login or register to post a reply.

Sponsored links