Rack and pinion removal

Tiny
OSPOMRL
  • MEMBER
  • 1992 HONDA ACCORD
  • 219,000 MILES
I have all disconnected and ready for removal but I do not have a torch or impact gun to remove exhaust pipe for clearance. Can I loosen or remove sub frame bolts to remove instead? Shaft through the floor board is the problem.
Wednesday, December 21st, 2011 AT 5:08 AM

3 Replies

Tiny
FACTORYJACK
  • MECHANIC
  • 4,159 POSTS
If your gear is ready for removal, this shaft should already be disconnected. I cannot guarantee with any certainty, that the frame will lower enough to get you the clearance that you need. You can try it, have it supported, and lower slowly to see if you can accomplish.
Was this
answer
helpful?
Yes
No
Wednesday, December 21st, 2011 AT 5:13 AM
Tiny
OSPOMRL
  • MEMBER
  • 2 POSTS
Thanks, I will try.
Was this
answer
helpful?
Yes
No
Wednesday, December 21st, 2011 AT 5:40 AM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
You need to remove the exhaust to get sufficient clearance.

DO NOT use an impact to loosen the exhaust bolts and nuts. You would definitely strip them. Spray some rust penetrant onto the threads and use a socket wrench to remove the nuts.

If automatic, I would advise disconnecting the shift cable as well. If you try to pull too hard onto the cable, chances are you would damage it resulting in stiff lever movement when shifting in and out of Park.

Removing driver side tie-rod end would gain you more space.
Was this
answer
helpful?
Yes
No
Wednesday, December 21st, 2011 AT 2:25 PM

Please login or register to post a reply.

Sponsored links